Which material for which job? PLA, PETG, ASA, TPU and more

Updated:

A decision guide to 3D printing materials: properties, temperature limits and typical uses of PLA, PETG, ASA, TPU, nylon and fibre-reinforced plastics.

The material question can almost always be settled with four counter-questions: Will the part get warm? Will it live outdoors? Does it need to flex? How much do looks matter?

MaterialStrengthsLimitsTypical use
PLAaccurate, good surface, many colours, low costsoftens from about 55 °C, rather brittlemodels, indoor housings, prototypes
PETGtough, up to about 75 °C, moisture-resistantslightly less crisp detailbrackets, workshop, kitchen and bathroom (no food contact)
ASAUV- and weather-resistant, up to about 95 °Ccosts a little more, large flat areas may warp slightlyoutdoors, vehicles, garden
TPUrubber-like, abrasion-resistantno fine detail, no tight tolerancesseals, bumpers, protective sleeves, feet
PA (nylon)very tough, low frictionabsorbs moisturegears, hinges, sliding parts
PLA-CF / PETG-CFvery stiff, matt surfacemore brittle, more expensiverigid brackets, jigs, visible parts
PChigh heat and impact resistancedemanding to printcovers near heat sources

Temperatures are guide values and depend on the specific filament.

Quick picker

  • Indoors, no load, should look good: PLA
  • Has to take some stress or gets damp: PETG
  • Sits in the sun or in a car: ASA
  • Must bend or cushion: TPU
  • Rubs, slides, clicks into place: PA
  • Must be especially stiff: fibre-reinforced (CF)

Three points people often miss

  1. The car in summer. Behind a windscreen temperatures exceed 70 °C. PLA deforms there.
  2. Food contact. FDM parts have fine grooves where residue collects. Without a suitable coating they are not meant for lasting food contact.
  3. Colour and material are linked. Not every colour exists in every material. Ask early if the colour is fixed.

FAQ

Which material is the strongest?

It depends on the load. PETG and PA forgive impacts; CF materials are the stiffest but tend to snap instead of bending.

Is PLA environmentally friendly?

PLA is made from plant starch. It only breaks down in industrial composting plants, though, not in a garden compost heap or in nature.

Straight to the price

Upload a file, pick a material, see the price. From 1 piece, dispatched in 1 working day or picked up in Berlin.

Get an instant price

Upload a part and see the price

Upload your file and see the price at once. Without a file, a photo with dimensions is enough.

Get an instant price