Design rules for FDM 3D printing: walls, overhangs, fits

Updated:

The key design rules for printable FDM parts, with concrete guide values for wall thickness, overhangs, holes and fits.

These guide values apply to FDM with a 0.4 mm nozzle. Following them saves support material, print time and finishing.

FeatureGuide value
Minimum wall thickness0.8 mm, better 1.2–2 mm
Overhang without supportup to about 45° from vertical
Bridge without supportup to about 20 mm
Smallest detailabout 0.8 mm
Raised or engraved textstroke width from 0.5 mm, height/depth from 0.5 mm
Clearance for push fits0.2–0.3 mm
Clearance for moving parts0.4–0.5 mm
Holescome out about 0.1–0.2 mm undersized
Printed threadsfrom roughly M6; below that use a threaded insert

Five rules that matter most

  1. Plan a flat base. A part that sits fully on the build plate is more accurate and cheaper.
  2. Chamfers instead of fillets underneath. A 45° chamfer prints cleanly; a downward-facing radius does not.
  3. Put the load along the layers. A hook whose layers run across the pull direction breaks early. Tell us where the force acts.
  4. Avoid sharp inside corners. A small radius spreads the stress.
  5. Ribs instead of bulk. Thick solid sections cost material and warp. Walls with ribs are stiffer and lighter.

Joints

  • Screws into plastic: For joints that are opened often, have brass threaded inserts heat-set.
  • Snap hooks: Make them long and thin, print them parallel to the build plate and choose PETG or PA.
  • Plug and glue: Locating pins or tongue-and-groove make it easier to align split parts.

Tip: For critical fits, first order a small test piece with two or three clearance values. It costs little and avoids a failed print of the large part.

FAQ

Why are holes smaller than designed?

The plastic shrinks slightly as it cools, and circles are printed as polygons. Design them 0.1–0.2 mm larger or have them reamed.

What is infill?

The inside of a part is usually not printed solid but with a lattice of 15–40 %. More infill adds less strength than a thicker outer wall.

Straight to the price

Upload a file, pick a material, see the price. From 1 piece, dispatched in 1 working day or picked up in Berlin.

Get an instant price

Upload a part and see the price

Upload your file and see the price at once. Without a file, a photo with dimensions is enough.

Get an instant price